CIRRUS FOGGER
The CIRRUS produces a thermal fog that is comprised of virtually uniform size droplets that can be as small as 0.3 micron in diameter. Small droplets spread instantly throughout the target space, envelop all objects, readily collide with flying insects, penetrate deeply and deposit equally in all directions. The fog can be pressurized, ducted or agitated by a fan without loss in quality, allowing the simultaneous treatment of separate structures or enhanced distribution. The Cirrus can be controlled from outside the target area by a wired remote control allowing the gradual release of fog to prolong target exposure time. The unit is extremely economical to operate.
QUALITY DESIGN
ISO 9001 approved
OPERATIONAL TECHNOLOGY
Fog fluid is mixed with inert gas and delivered into the heat exchanger under
pressure where it is vaporized. The vapor condenses on reaching the air to form
a dense concentration of fine droplets. The Cirrus produces droplets that can be
uniquely small and are much more uniform in size than those from conventional
fogging machines. The fogger is designed to operate unattended allowing
continuous slow release of fine droplets for maximum effectiveness and guarding
against operator exposure. The Cirrus can deliver fluids continuously when
matched with a suitably sized external fluid reservoir.
SPECIFICATIONS OPTIONS
| Weight:
|
26lbs.
(11.8 kg) |
|
| Size
(H x W x L): |
16"
x 7" x 14½" (41 x 18 x 37 cm) |
|
| Output: |
±2
liters/hr* |
|
| Operating
time
Internal reservoir:
External reservoir: |
±25
minutes* continuous,
dependent on reservoir size |
|
| Fog
droplet size: |
0.3
micron or larger as required |
|
| Warm
up time from cold: |
3
minutes |
|
| Power
consumption: |
2.3
KWh at 110 Volt (220 volt optional) |
|
| *
depending on fluid viscosity
|
|